I just launched Cobian Reflector.
Usually the list used previously is loaded automatically.
This time I did not see anything loading.
I checked, there is a list file "MainList.lst" in the "Lists" subdirectory of the installation.
I had to open it manually to get it to load.
List not loaded at start
Re: List not loaded at start
Perhaps you started the user interface and not the application.
--
Luis Cobian
Cobian Backup's creator
Luis Cobian
Cobian Backup's creator
Re: List not loaded at start
I have the same issue. It seems that the source of the problem is that the engine does not automatically start when Windows 11, in my case, restarts. I checked in the services and it shows Cobian Engine >> Automatic. But I have to manually start it. I went in the Cobian Interface >>> Tools >> Service and Application Control Set. Under the Autostart tab, the engine autostart is grayed out. Not sure if I should reinstall the application or is there a setting to set the autostart ON so that the Cobian engine starts on every Windows reboot.
Re: List not loaded at start
If the program is installed as a service, then the "Autostart the application" is disabled. The service should start automatically. Check the event viewer to see if some error is preventing the service to start automatically.
--
Luis Cobian
Cobian Backup's creator
Luis Cobian
Cobian Backup's creator