Execute and Wait can find path with a space in it

[Todd]

Cobian 2.7.20

Execute and wait can not find a program with a space in the path. Execute and wait can not execute "C:\Program Files\Rakudo\bin\raku.exe" but can execute "C:\Rakudo\bin\raku.exe".

Once I realized what was happening, I had to uninstall Rakudo and reinstall it in the root of c:

[Boonew]

did a test to open windows media player pre-baup task and it works just fine..?

Code: Select all

    2024-08-29 13:51:54 Backing up the task "Test Task"
    2024-08-29 13:51:54 Applying the parameters to the task "Test Task" (if any).
    2024-08-29 13:51:54 Executing the pre-backup events...
    2024-08-29 13:51:54 Executing the program: C:\Program Files\Windows Media Player\wmplayer.exe...
    2024-08-29 13:51:54 The program C:\Program Files\Windows Media Player\wmplayer.exe has been successfully executed.
    2024-08-29 13:51:54 The pre-backup events have been executed.
    2024-08-29 13:51:54 Requesting the creation of a Volume Shadow Copy image for the source...
    2024-08-29 13:51:57 The Volume Shadow Copy image has been successfully created.

also I'm able to edit and modify, the pre-backup tasks..

[Todd]

The subject lien should say "can't" not "can"

About 1 out of 10 installs of Reflector I can edit Execute and Wait. (They are all upgrades from Backup at some point.)

I do believe the issue here is that the upgrade does not clean up after itself after importing old settings. I had one last week where the target path got randomly mixed up between two different tasks. I had to completely remove Reflect including its directory on the hard drive and reinstall it to correct the issue.

[cobian]

TEsted with "c:\Program Files\Notepad++\notepad++.exe". It was executed without problems.

[Boonew]

The subject lien should say "can't" not "can"

About 1 out of 10 installs of Reflector I can edit Execute and Wait. (They are all upgrades from Backup at some point.)

I do believe the issue here is that the upgrade does not clean up after itself after importing old settings. I had one last week where the target path got randomly mixed up between two different tasks. I had to completely remove Reflect including its directory on the hard drive and reinstall it to correct the issue.

no problem, I Understood your initial post by reading the contents

[Todd]

TEsted with "c:\Program Files\Notepad++\notepad++.exe". It was executed without problems.

Try it again after upgrading from reflector 1.0.0.

[cobian]

Perhaps the format changed from 1.0. I'm almost sure.