Page 1 of 1
Run task from CMD when CR is a service
Posted: 22 Jan 2022, 21:03
by antonio1981
Cobian Reflector was installed as a service. Is there any CMD command to run specified backup task? Or any other method?
I need to run backup just before computer shut down.
I know the CMD command when CR is installed as application, but I need it when CR is installed as a service.
Re: Run task from CMD when CR is a service
Posted: 22 Jan 2022, 23:18
by cobian
Unfortunately a service cannot be controlled the same way than an application. But why don't you start the needed task from the user interface?
Re: Run task from CMD when CR is a service
Posted: 23 Jan 2022, 09:54
by antonio1981
I'm using Cobian Reflector (CR) to copy user's files on Windows 10 Home. CR has security password, unknown by user, so user can't use interface, beacause possibility of change/destory task configuration.
I'd like to crete some kind of .cmd script contains 2 commands:
- run backup task in CR
- shutdown system.
If it's not possible when CR is a service, then OK. I will reinstall it as an application.