I'm probably doing something daft, but I setup an incremental task. I did my initial backup and have all the folders with "(Full)" after them, as you'd expect. I then plugged in my USB backup drive again a few days later and told it to run all tasks again; getting additional folders with "(Incremental)" after them. So far so good.
However, when looking inside these folders, it's another full backup. Comparing them to the "Full" ones, the number of files and size is identical for folders which haven't changed in the days between the backups.
The History tab shows the full backup ran OK
Example bit of log output:
Code: Select all
2021-10-25 16:03:12 The destination directory "E:\XXX\XXX\XXX 2021-10-25 16;03;12 (Incremental)" has been successfully created.
2021-10-25 16:03:12 Backing up the directory "D:\XXX" to "E:\XXX\XXX\XXX 2021-10-25 16;03;12 (Incremental)"...
2021-10-25 16:03:20 The directory "D:\XXX" has been backed up.
Folders on E (backup USB drive):
"Full" version: 626MB, 3 files
"Incremental" version: 626MB, 3 files
The files haven't changed in years, they are video recordings.
Anyone got any ideas?